4:51:41your missing something for the inserters
4:51:58to make the circuits you will need to split a copper segment from the bus
4:52:25You could loop around the right side too
4:52:29yeah that should be fine, you can press V or H to flip it
4:52:40splitting the merged belt/inserter is probably easiest
4:52:41You've got plenty of assemblers making belts and inserters for science
4:52:45I wouldn't bother doing a mirror design since the bottleneck is belt capacity
4:52:53but you can avoid the split by just making green on the bottom
4:53:13yeah that i was saying 10 minutes before
4:53:31And pull copper plates from the bus
4:53:43she is getting it :_emberGGs:
4:53:55Haha the purpose of the bus becomes clear
4:54:13wdym, is it not artistic enough?
4:54:17extend your bus so that you can see it more clearly
4:54:52use underground there to cross over, remember that your bus is 4 lanes wide
4:55:15You'll learn to appreciate full belts
4:55:15and now you've fully automated red science
4:55:19now just got to feed the labs somehow
4:55:49then you see the issue immediately
4:55:52the copper crossing 4 lanes of iron
4:55:55extend your 4 lanes of metals on your bus
4:55:59Teh resources you pulled off the bus should go through underneathies.
4:56:07the bus will keep going as your factory grows
4:56:16The undergrounds go 4 spaces underground max
4:56:50gato probably wants some attention or cuddles?
4:56:54hello Gato!:_emberHello::_emberHello:
4:57:08faster undergrounds can go further underground later
4:57:10That's why people use 4-wide busses
4:57:11@EmberAmane you better prolong iron lanes of bus and then branch out cooper to see where to put UGs